Within the newest installment of Mark’s Trans Am challenge, he addresses the rotted-out tail panel. Earlier than putting in an aftermarket substitute, he begins by chopping out the unique half and treating extra rust within the surrounding areas. Watch as he fabricates new bumper mount panels from scratch.
This replace was an enormous one, with Mark pulling out all the large instruments: a rotary removing instrument with wire wheel for stripping seam sealer, plasma cutter and spot weld cutters to take away the outdated panel, a spot blaster to hit the floor rust, a bead curler and panel bag to manufacture restore panels, and a MIG welder to place all of it collectively. As all the time, it’s fascinating to look at how meticulous and thorough Mark is when he works.
Make your self a sandwich and luxuriate in it for eight minutes whereas Mark does all of the arduous work within the video beneath:
